Cut-Of f Tools CW17 WFHF CW B H B HF H WF CWHF BH HF H SumiGrip WCFS Type For Cut-off Cut-off (Carbide Holder/Shank Type) WCFS Brazed Blade Type ● Insert Mounting MethodBlade Clamp Type Insert Mount the insert by lightly 26.5 knocking it in with a Cut-off wooden or plastic hammer. Hammer (Check that the insert cannot be pulled out by hand.) LF 46 Note that driving in the insert too far may cause damage to the insert or holder. Fig 1 Fig 2 Fig 3 Fig 4 Maximum Cut-off Dia. Maximum Cut-off Dia. LF LF F 46 46 LH LH LH LH Figure shows right hand (R) tool. Holder Parts  Dimensions (mm) Type Cat. No. Stock Height Width Overall Length Cutting Edge Height Head Width of Cut Max. Cut-OffRLHBLFHFLHCWDiameterApplicableBladeApplicableInsert Fig Wrench WCFS R/L1010-2 ●● 10 10 86 10 10 2.0 28 Q WCF□2○ 1 Brazed Type R/L1212-2 ●● 12 12 110 12 18 2.0 30 Q WCF□2○ 1 SL-2R/L1616-2●●161610016252.035QWCF□2○2 R/L1616-3 ●● 16 16 100 16 25 3.0 35 Q WCF□3○ 2 SL-1 WCFS R/L20-3 ●● 20 20 125 20 46 3.0 50 WCFH17-3 WCF□3○ 3 R/L20-4 ●● 20 20 125 20 46 4.0 50 WCFH17-4 WCF□4○ 3 SL-1 Clamp type R/L20-5WCFS R/L25-3 ● 20 20 125 20 46 5.0 50 WCFH17-5 WCF□5○ 3●●252515025463.050WCFH17-3WCF□3○4 R/L25-4 ●● 25 25 150 25 46 4.0 50 WCFH17-4 WCF□4○ 4 SL-1 R/L25-5 ● 25 25 150 25 46 5.0 50 WCFH17-5 WCF□5○ 4 Refer to F65 for applicable inserts. Blade is included with the holder. Fig 1 26.5 44.5 Blade  Dimensions (mm) Parts Cat. No. Stock Width of CW Cut WidthB ApplicableHolderWCFH 17-3●32.4WCFS R/L20-3,25-3 Cap Screw WrenchApplicable Holder WCFH 17-4 ● 4 3.4 WCFS R/L20-4,25-4 WCFH 17-5 ● 5 4.3 WCFS R/L20-5,25-5 WCFS R/L20-○, WCFS R/L25-○ BX0622 LH050 F64