Заказ инструмента: http://steelcam.org | 8 (343) 382-52-03 | [email protected] 80.0VSE45-_R-12 Series Cartridge Face Milling Cutter Facing Spiral / Circular 45° CARTRIDGE FACE MILLING ASSEMBLIES 80_0VSE-45-_R-12 The 80.0VSE45 cutter series is primarily designed to machine Stainless Steel and High Temperature Alloys. Also Steel, Steel Alloys, Cast Iron and Aluminium can be machined. 8000VSE45-_R-12: Especially, if thin wall components need to be machined. Due to its very positive design Maximum ap = 7,00mm requires this cutter series lower power. Effective Cutting Diameter Range = 100mm to 400mm The square inserts design with 15° degrees clearance and very positive chip geometry is ** Denotes non stock items diameter ideal for reducing build-up edge on tough materials. 315mm - 400mm Applications: The 80.0VSE45 cutters are assembled with cartridges for SD..1204.. milling inserts. These 8010VSE45-_R-12: cutters are ideal for face milling applications. Available with medium pitch. Maximum ap = 7,00mm Effective Cutting Diameter The 8000VSE45 cutter series has an unequal medium pitch for reducing vibration and are Range = = 100mm to 200mm mainly for roughing, semi-finishing and finishing of Steel, Steel Alloys, Stainless Steel, Cast ** Denotes non stock items diameter Iron and Aluminium. 100mm - 200mm The 8010VSE45 cutters series has an equal medium pitch and is especially recommended for roughing, semi-finishing and finishing of High Temperature Alloys such as Iron Based Alloys, Cobalt Based Alloys, Nickel Based Alloys and Titanium. Also, the 8000VSE45 cutter series can be mounted with a particular wiper cartridge for finishing when a fine finished surface is required. The corresponding pocket on the body for the finishing cartridge is marked with a “F”. Note: The 8010 series are not possible to assemble with a wiper cartridge. www.kennametal.com A141