Заказ инструмента: http://steelcam.org | 8 (343) 382-52-03 | [email protected] 80.0VOD45-_R-04 Recommended Speeds Speed vc (m/min) Cartridge Face Mills 80.0VOD45-_R-04 Wear Resistance Series -- + Speed min. - max.. Coolant Recommendation CVD PVD PVD CVD CVD Uncoated Uncoated Recommended  Possible  X Grade X Grade Standard Standard Standard Micrograin Cermet ISO Materials Rm and X500 X700 SP6519 MP91M SC3025 GH1* SA9608 Hardness <600 N/mm2 130 - 270 130 - 295 140 - 345 240 - 345 265 - 380 Unalloyed <180 HBN        Steel <950 N/mm2 115 - 240 115 - 260 120 - 305 215 - 305 235 - 335 <280 HBN P 700-950 N/mm2 100 - 210 100 - 230 105 - 270 190 - 270 205 - 295 200-280 HBN        Alloyed 950-1200 N/mm2 75 - 160 75 - 175 80 - 205 140 - 205 155 - 225 Steel 280-355 HBN 1200-1400 N/mm2  50 - 100  50 - 110  50 - 130  90 - 130  100 - 145 355-415 HBN Austenitic + Ferritic 115 - 250 115 - 260 115 - 270 215 -305 235 -335 Stainless 300 series           M Steel Martensitic 100 - 220 105 - 230 105 - 235 195 - 275 215 - 305 400 series PH Stainless Refractory  50 - 110  50 - 115  50 - 120  90 - 180  100 - 200 P.H. Grey 140 - 295 145 - 365 150 - 395 135 - 290 280 -400 GG-Ft K Cast Iron Spheroidal-Ductile   110 - 240  115 - 285  120 - 335   120 - 245  220 -315 GGG-FGS Malleable 100 - 220 105 - 260 105 - 275 115 - 200 200 -285 GTS - MN/MP Aluminium & Alloys 400 - 3050 N Aluminium < 16% Si 116 HBN & Alloys  Aluminium + Silicon 295 - 2440 > 16% Si 92 HBN Iron Based 23 - 48 23 - 52 23 - 55 50 - 75 High Cobalt Based 21 - 44 22 - 46 22 - 48 48 - 70 S Temperature     Alloys Nickel Based 24 - 51 25 - 53 25 - 55 52 - 75 Titanium Based 35 - 73 36 - 75 36 - 79 60 - 95 Hard Steel >1400 N/mm2 H Hard >415 HBN Materials Chilled Cast Iron >1400 N/mm2 > 400 HBN * Note: ODET04..-441 in Grade GH1 can only be used for Aluminium. * Note: Wiper Insert SPHX12M512EN GH1 can be used for Steel, Steel Alloys, Stainless Steel, Cast Iron and High Temperature Alloys. www.kennametal.com A129