Каталог Iscar отрезка 2022 - страница 5
Навигация
Токарные инструменты Iscar (часть 1) 2026
Каталог Iscar монолитные фрезы 2022
Инструменты для обработки отверстий Iscar 2026
Каталог Iscar резьбонарезные фрезы
Каталог Iscar расточные системы
Каталог Iscar токарный инструмент 2017
JT-Type J-Type
Based on the J-type chipformer with a First choice for soft materials, parting tubes, T-land reinforced frontal cutting edge. small diameters and thin-walled parts
- Provides a solution for the intermediate range
- Cutting edge with positive rake
between the strong and negative C-type configuration Low-to-medium feed and the positive edged J-type chipformer. W insert
Can be used on a wide range of materials. f ≈ [mm/rev]
26
- Same manner as the J-type, but it can be used at higher feeds due to its reinforced edge.
High
W insert Alloy Austenitic Nonferrous Cast
f ≈ [mm/rev] Temp.
| 24 | Steel | Stainless | Materials | Iron | |||||
| Alloys | |||||||||
| 3 | 3 | 3 | 3 | 7 | |||||
| High |
| Alloy | Austenitic | Nonferrous | Cast | Recommendations are for neutral inserts. | ||||
| Temp. | ||||||||
| Steel | Stainless | Materials | Iron | For R/L inserts, reduce feed by 20-40%. | ||||
| Alloys | ||||||||
| 3 | 3 | 3 | 7 | 3 |
4°
5° 7°
Recommended feed range as a function of insert width 7° Feed mm/rev Recommended feed range as a function of insert width 0.25 Feed mm/rev 0.22 0.30 0.18 0.25 0.14 0.20 0.10 0.15 0.06 0.10
Width 0.02 Width
2 3 4 5 6 7 mm 1.0 1.4 1.6 2.0 3.0 4.0 5.0 6.0 mm