Каталог Iscar дисковые фрезы и фрезерные пластины 2022 - страница 21
Навигация
Каталог Iscar крепление инструмента
Каталог Iscar инструмент для обработки отверстий
Каталог Iscar резьбонарезные фрезы
Каталог Iscar инструмента для сверления
Каталог Iscar решения для глубокого сверления
1 4 Indexing
ETS L -type key is added to the cutter package. It has a ball shape on the end of its longer side.
SDN FDN Feed Direction: Down (climb) milling is recommended.
LNET 2 Setting the Overhang ETS..- T-type Slotting Cutters Overhang Designation Do not clamp insert with a broken corner
DC OHN OHX
(min) (max) in the outer bottom position.
| ETS D32 | 32 | 20 | 49 | |
| ETS D40 | 40 | 34 | 63 | ✗ |
| ETS D50 | 50 | 27 | 66 | |
| ETS D63 | 63 | 27 | 66 |
∅DC Overhang
OHX OHN
5 Tightening Torque 60-70 N x cm 6 Tightening
| 3 Lubrication - Important! | Use the short side for | Use the long side for | |
| For every indexing, lubricate screws before mounting. | tightening and initial release | quick driving and release |
Grease should cover the screw’s thread and cone head. Important note: To avoid indexing problems, insert clamping screws and replace keys on a regular basis according to their wear. 7 Width of Cut for a =3 - 6.5mm - use the following table
p
| a | Insert | Screw | Key |
| p |
| 3.00 | LNET 081804-TN-N | SR 114-018-L2.50 | |
| 4.00 | LNET 082604-TN-N | ||
| SR 114-018-L3.40 | |||
| 4.50 | LNET 082804-TN-N | ||
| 5.00 | LNET 083004-TN-N | SR 114-018-L4.40 | T-6/5 |
| 5.50 | LNET 083204-TN-N | SR 114-018-L4.40 | T-6/5-L |
6.00 LNET 083504-TN-N SR 114-018-L5.30 6.50 LNET 083704-TN-N