Общий каталог Ingersoll 2011 - страница 1265

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

GENERAL TECHNICAL INFORMATION TROUBLE SHOOTING (EN) PROBLEM CAUSED BY SOLUTION • Cutting speed too high • Reduce RPM • Infeed depth too small • Increase depth of cut • Modify flank infeed • Highly abrasive material • Use coated grade • Inadequate coolant supply • Apply coolant • Wrong inclination anvil • Reselect anvil • Wrong turned dia. prior to threading • Check turned dia. Premature wear • Insert is above centerline • Check center height • Cutting speed too high • Reduce RPM • Depth of cut too large • Reduce depth of cut • Wrong grade • Use coated grade • Use tougher grade • Poor chip control • Modify flank infeed • Inadequate coolant supply • Apply coolant Chipped edge • Center height incorrect • Adjust center height • Excessive heat in cutting zone • Reduce RPM • Reduce depth of cut • Check turned dia. • Wrong grade • Use coated grade • Use harder grade • Apply more coolant Plastic deformation • Inadequate coolant supply • Cutting edge too cold • Increase RPM • Increase depth of cut • Wrong grade • Use coated grade • Inadequate coolant supply • Apply coolant Built-up edge • Cutting speed too low • Increase RPM • Depth of cut too large • Reduce depth of cut • Increase number of infeed passes • Wrong grade • Use tougher grade • Wrong turned dia. prior to threading • Check turned dia. • Corner height incorrect • Adjust center height • Infeed depth too shallow • Modify flank infeed Broken noseduring 1st pass • Wrong inclination anvil•Tool overhang too long • Reselect anvil•Reduce tool overhang Poor surface finish • Wrong cutting speed • Increase RPM • Reduce RPM • Excessive heat in cutting zone • Reduce depth of cut • Poor chip control • Modify flank infeed • Inadequate coolant supply • Apply coolant • Wrong inclination anvil • Reselect anvil • Tool overhang too long • Reduce tool overhang • Center height incorrect • Check center height Poor chip control • Excessive heat in cutting zone • Reduce RPM • Change depth of cut • Wrong grade • Use coated grade•Check turned dia. • Use M-type insert • Inadequate coolant supply•Wrong turned dia. prior to threading•Apply coolant•Check turned dia. 1267