Производственная мебель и системы хранения Hoffmann Group 2026 - страница 483

GBP 57 ​ Floor marking adhesive tapes Standard: DIN EN ISO 7010, ASR 1.3, ASR 1.5/1,2, DIN 51130. Self-adhesive extra thick floor marking tape for indoor use. Slip prevention R10 to ASR 1.5/1.2 floors. Abrasion-resistant and hard-wearing thanks to the high-quality extruded material. Thickness 1.2 mm. Strong adhesive bond thanks to the bevelled edges. These prevent damage to the floor marking tape when moved over. Suitable for areas where there is fork-lift truck traffic (without any turning, steering or braking movement). Detail Type WHITE RED YELLOW GREEN BLUE Floor marking tape 96 4950 97M eShop eShop eShop eShop eShop 1.2 mm thick Adhesive Acrylate Colour white red yellow green blue Length m 30 Width mm 50 Thickness mm 1.2 Self-adhesive two-tone floor marking tape for indoor use. For robust and long-lasting marking of gangways and carriageways in stores and in operating areas. Slip prevention R9 to ASR 1.5/1.2 floors. Thickness 0.7 mm. Suitable for areas where there is fork-lift truck traffic (without any turning, steering or braking movement). Type Y/B R/W G/W Floor marking tape 96 4953 97M eShop eShop eShop 0.7 mm thick Adhesive Acrylate Colour yellow-black red-white green-white Length m 30 Width Thickness mm mm 50 0.7 96 Self-adhesive floor marking tape for indoor use. For long-lasting marking of gangways and carriageways in stores and in operating areas. Abrasion-resistant and hard-wearing. Slip prevention R9 to ASR 1.5/1.2 floors. Thickness 0.5 mm. Suitable for areas where there is fork-lift truck traffic (without any turning, steering or braking movement). Type WHITE RED YELLOW GREEN BLUE Floor marking tape 96 4956 97M eShop eShop eShop eShop eShop 0.5 mm thick Adhesive Acrylate Colour white red yellow green blue Length m 30 Width mm 50 Thickness mm 0.5 Instructions for applying floor marking tapes: ■ Before application the floor must be clean and dry. ■ Clean the floor with isopropyl alcohol and allow it to dry for 30–60 minutes. ■ Optimum adhesion at an application temperature between 15 – 20°C. ■ Perform an adhesion test using a small piece of adhesive tape. ■ Press the adhesive tape on using a spreading knife or roller, taking care to apply sufficient contact pressure. ■ Form corners by means of a diagonal cut or butt joint. ■ The adhesive tape can be walked on after 10 minutes, driven over by fork-lift trucks after 24 – 48 hours. ■ Do not perform fork-lift truck turning, steering or braking manoeuvres on the adhesive tape. 483