Technical Info Technische Info General Technical Inform · Allgemeine Technische Info The shaft lower deviation(ei) and upper deviation (es) can be obtained by basic tolerance and standard tolerance (IT) of shaft. Toleranz Einheitswelle: Die geringste Abweichung (ei) und die größte Abweichung (es) sind als Basis bzw. Standard-Toleranzen (IT) in der Tabelle angegeben.Deviation from a to hDeviation from k to zc D Abweichung von a bis h Abweichung von k bis zc + es 0 line ei 0 es ei - ES= negative (-) basic tolerance of hole EI= positive (+) basic tolerance of hole ES= neg(-) Basistoleranz der Bohrung EI= pos(+) Basistoleranz der Bohrung ei=es-IT es=ei+IT The hole lower deviation(EI) and upper deviation (ES) can be obtained by basic tolerance and standard tolerance (IT) of hole. Toleranz Einheitsbohrung: Die geringste Abweichung (EI) und die größte Abweichung (ES) sind als Basis bzw. Standard-Toleranzen (IT)- Bohrung in der Tabelle angegeben. Deviation from a to h Deviation from K to ZC Abweichung von A bis H (It is not applicable for K, M with the tolerance < IT8) Abweichung von K von ZC + (Ist nicht anwendbar für K, M mit der >Toleranz < IT8) ES EI 0 line 0 ES EI - EI= postive (+) basic tolerance of hole ES=negitive (-) basic tolerance of hole EI= pos(+) Basistoleranz der Bohrung ES= neg(-) Basistoleranz der Bohrung ES=EI+IT EI=ES+IT For example: for a hole with diameter 3 mm and tolerance H7, we can find that the lower deviation EI=0 in relation to H7 from the basic tolerance table, and the standard tolerance IT=10μm corresponding to H7, thus the upper deviation ES=EI+IT=10μm. Therefore the hole fitting dimension is Ø 3+00.01mm. Beispiel: Bei einem Durchmesser von 3mm und einer Toleranz H7 ist bei der Basis Toleranz H7 EI=0 bei der Standard-Toleranz H7 ist es IT=10μm. Die größte Abweichung ist demzufolge: ES=EI+IT=10μm. Die Bohrungstoleranz ist bei einem Ø 3+00.01mm. D 11