Общий каталог Sumitomo 2018 - 2019 - страница 408

• Pages 3-6_CS6_EN_web
• A 1-20 insert selection EN_web
• B 1-14 grades_EN_web
• C01-17 inserts intro pages_EN_web
• C18-56 negative inserts_EN_web
• C57-86 positive inserts_EN_web
• D 1-46 tool holders_EN_web
• E 1-24 boring bars_EN_web
• F 1-48 grooving_thread tools_EN_web
• G 1-54 milling cutters_EN_web
• H 1-48 insert type endmills_EN_web
• J 1-24 new endmills_EN_web
• J 25-50 endmills_EN_web
• K 1-46 Multi-Drills_EN_web
• K 47-76 Multi-Drills_EN_web
• L 1-28 cbn_pcd grades_EN_web
• M 1-34 cbn_pcd inserts_EN_web
• M 35-56 SHM tools_EN_web
• N1-24 technical guidance_EN_web
• P 1-8 spare parts_neu_EN_web
• P 9-22 index_notes_EN_web

SumiDrill Power Series New SDM Type Chip Control Drill: Ø 8mm, L/D=5 Work Material: X5CrNiS18 10 (1.4301) Cutting D ata: vc=60m/min, f=0,10mm/rev, ap=19mm Internal coolant (2,0MPa) SDM Competitor A Short chips, Partial long chips, good chip evacuation risk of tool breakage by poor chip evacuation Optimal Cutting Forces Drill: Ø 8mm, L/D=5 Work Material: X5CrNiS18 10 (1.4301) Cutting Data: vc=60m/min, f=0,20mm/rev, ap=40mm Internal coolant (2,0MPa) 10% lower than competitor A SDM Competitor Cutting Time Cutting Time Unstable Low Burr Formation 0,3 Drill: Ø 8mm, L/D=5 0,6 Lowburr Work Material: X5CrNiS18 10 (1.4301)Cutting Data:vc=60m/min, f=0,20mm/rev, ap=40mmInternal coolant (2,0MPa) 0,4 0,2 0 SDM Competitor A Competitor B Burr (mm) 0,20 0,24 0,77 SDM Competitor A Competitor B K13 Burr Height Cutting Force (N) Cutting Force (N) Multi-Drills