Общий каталог SGS 2021 - страница 41

FRACTIONAL Z-Carb-AP 38° 35° 4 ≠ ≠ LF LU DC DCON RE APMX DN Z1PLCFRACTIONAL SERIES TOLERANCES (inch) inch EDP NO. • Variable rake geometry 1/4 DIAMETER CUTTING LENGTH OVERALL SHANK REACH NECK CORNER Ti-NAMITE-X alters and controls the DC = +0.0000/–0.0012 DIAMETER OF CUT LENGTH DIAMETER LU DIAMETER RADIUSDCAPMXLFDCONDNRE cutting dynamic takingchatter suppression to DCON = h6RE= +0.000/–0.005>1/4–3/8 DIAMETERDC= +0.0000/–0.00161/41/22-1/21/4 1-1/8 .230 .020 36447 an unprecedented level1/41/23-1/21/41-5/8.230.02036448• Unequal helix designchanges the cutting1/41/241/41-1/4.230.02036450angle to improveharmonics DCON = h6 1/4 1/2 4 1/4 2-1/8 .230 .020 36449 • Unequal flute spacing RE = +0.000/–0.005 5/16 13/16 3 5/16 1-3/8 .293 .020 36453 helps to disrupt the >3/8–1 DIAMETER 5/16 13/16 4 5/16 2 .293 .020 36454 rhythmic patterncreated by the cutting DC = +0.0000/–0.0020 5/16 13/16 4 5/16 1-5/8 .293 .020 36452 edge helping to DCON = h6RE= +0.000/–0.005 3/8 7/8 3 3/8 1-5/8 .355 .020 36457 suppress damagingharmonics3/87/853/81-7/8.355.02036456• Long reach design STEELS 3/8 7/8 4 3/8 2-3/8 .355 .020 36458 allows for deeper andfaster cuts7/16167/162.418.02036460• Enhanced corner STAINLESS STEELS 1/2 1 4 1/2 2 .480 .030 36463 geometry with tight tolerance corner radii CAST IRON 1/2 1 5 1/2 3 .480 .030 36464 • Recommended for 1/2 1 6 1/2 2-1/4 .480 .030 36462 materials ≤ 45 HRc HIGH TEMP ALLOYS 9/16 1-1/8 6 9/16 2-1/2 .543 .030 36466 (≤ 420 Bhn) TITANIUM 5/8 1-1/4 5 5/8 2-1/2 .605 .040 36468 HARDENED STEELS 5/8 1-1/4 6 5/8 3-3/4 .605 .040 36469 For patent 5/8 1-1/4 6 5/8 3 .605 .040 36470 information visit 3/4 1-1/2 6 3/4 3-1/2 .730 .040 36472 www.ksptpatents.com 1 1-1/2 6 1 3 .980 .040 36475 1 1-1/2 6 1 4 .980 .040 36474 www.kyocerEaN-DsgMstILoLoSl.com END MILLS 41