Общий каталог Mitsubishi 2020 - 2021 - страница 1111

Предыдущая страница Следующая страница

Навигация

iMX-CH3L

Chamfer head, 3 flute

CARBIDE

RECOMMENDED CUTTING CONDITIONS

y Camfer Milling(Hole Circumference)(inch)
W Matork erialCarbon Steel, Alloy Steel, Gray CastIronAlloy Tool St Pre-hardeneeel, Carbon d SteelSteel, AlloySteel,Austenitic Stainless Steel, TitaniumAlloy
D (mm)C (inch)Revolution n (min-1)Feed Rate vf (IPM)Depth of Cut apWidth of Cut aeRevolution n (min-1)Feed Rate vf (IPM)Depth of Cut apWidth of Cut aeRevolution n (min-1)Feed Rate vf (IPM)Depth of Cut apWidth of Cut ae
.375013006.2.071.07113004.7.071.07110003.6.071.071
10.393713006.2.071.07113004.7.071.0719703.5.071.071
12.472411005.3.085.08511004.0.085.0858102.9.085.085
.50009904.8.085.0859903.6.085.0857602.7.085.085
.62507903.8.094.0947902.8.094.0946102.2.094.094
16.62997903.8.094.0947902.8.094.0946102.2.094.094
.75006603.2.102.1026602.4.102.1025101.8.102.102
20.78746303.0.102.1026302.3.102.1024901.8.102.102
W Mat Depthork erial of CutHardennedSteel (40-55HRC)Heat Resist Inconel718ant Alloyap ae
DCRevolutionFeed Rate fDepth of CutWidth of CutRevolutionFeed Rate fDepth of CutWidth of Cut
(mm)(inch)n (min-1)v (IPM)apaen (min-1)v (IPM)apae
.375010002.4.071.07110004.8.071.071
10.39379702.3.071.0719704.7.071.071
12.47248101.9.085.0858103.9.085.085
.50007601.8.085.0857603.6.085.085
.62506101.5.094.0946102.9.094.094
16.62996101.5.094.0946102.9.094.094
.75005101.2.102.1025102.4.102.102
20.78744901.2.102.1024902.4.102.102
Depthof Cutap ae

Note 1) Vibration may occur if the rigidity of machine or work material is low. In this case, please reduce the revolution and the feed rate proportionately. Note 2) For stainless steel, titanium alloy and heat resistant alloy, the use of water-soluble coolant is effective.