Каталог Iscar монолитные фрезы 2022 - страница 14

ENDMILLS • SOLID CARBIDE • MULTI-MASTER SELECTION GUIDE TROCHOIDAL / DYNAMIC MILLING S (High Heat Resistant Alloys) Designation Ø LU (Neck) ap ZEFF Corner Type Coolant Page EC-E7/H7-CF 2-20 - 2xDC, 4xDC 7 - NO 119-120 EC-H-CF 6-20 - 2xDC 6-20 CHWx45 NO 123 HIGH FEED MILLING Designation Ø LU (Neck) ap ZEFF Corner Type Coolant Page EFP-E4,5CF 6-20 - 2.5xDC 4/5 RE NO 132 EFF-S 1-20 3xDC MIN. 2/4 RE NO 132 CHAMFERING AND DEBURRING Designation Ø LU (Neck) ap ZEFF Corner Type Coolant Page ECF.../45 4-12 - 2.5xDC 4 - NO 174 ECD-S2 3-12 2xDC 0.5xDC 2 - NO 174 *ROUGH: AE = 40% - Full Cut , ap = 1.5 x DC Material Group Parameters Nickel based Alloys31-35 Titanium and Ti Alloys36-37 Vc (IC900/608) (m/min) 20-40 30-50 Vc (IC300) (m/min) 20-30 20-40 ap Fz (Ø6–8) (mm/t) 0.02-0.03 0.02-0.03 Fz (Ø 10-12) (mm/t) 0.03-0.04 0.03-0.04 Fz (Ø 16-20) (mm/t) 0.03-0.07 0.03-0.07 AE SEMI-FINISH: AE = 10% - 40%, ap = 2 x DC Nickel based Alloys Titanium and Ti Alloys Material Group Parameters 31-35 36-37 Vc (IC900/608) (m/min) 40-50 50-60 ap Vc (IC300) (m/min) 30-45 40-50 Fz (Ø6–8) (mm/t) 0.03-0.04 0.03-0.04 Fz (Ø 10-12) (mm/t) 0.035-0.05 0.035-0.05 AE Fz (Ø 16-20) (mm/t) 0.05-0.08 0.05-0.08 FINISH / H.S.M: AE = 5% - 10%, ap = Max. cutting length Material Group Parameters Nickel based Alloys Titanium and Ti Alloys 31-35 36-37 Vc (IC900/608) (m/min) 50-70 60-70 Vc (IC300) (m/min) 45-60 50-60 ap Vc (IC902/903/702) (m/min) 55-80 65-80 Fz (Ø6–8) (mm/t) 0.035-0.05 0.035-0.05 Fz (Ø 10-12) (mm/t) 0.04-0.06 0.04-0.06 Fz (Ø 16-20) (mm/t) 0.06-0.085 0.06-0.085 AE 106 ISCAR