Каталог Iscar инструментальная оснастка 2022 - страница 65

CAMFIX DIN 26623-1 USER GUIDE CAMFIX Chucking Instructions Please be careful when In order to prevent too deep insertion of the clamping cylindrical shank cutting tools into CAMFIX cutting tools, the short length ER16, 20, 25, 32, holders such as ER collet chucks or EM holders. In 40 collet chucks and EM 6-50 mm endmill holders cases when the diameter of the shank is smaller than are equipped with permanent stoppers. the CAMFIX through hole, it may penetrate into the drawbar mechanism area and prevent proper clamping. Stopper washer Correct clamping Wrong clamping 4 7 Locking jaws ER chucks Face A special washer is installed as a permanent stopper. contact Preset screw Locking No face jaws are contact not located correctly Use a preset screw to The cutter shank prevent the cutter shank enters into the locking from entering into the mechanism zone, clamping mechanism preventing the drawbar zone, so the drawbar locking jaws to reach their locking jaws can correct clamping position. function correctly. 613