Общий каталог Ingersoll 2011 - страница 460

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

GENERAL TECHNICAL INFORMATION n INDEXING TIP GUIDELINES Replaceable SodliCabride M illiTnigps StrongV,ersatile Button Cutters Step 1: Screw tip into shank until finger tight (Figure 1a). Note a .010” gap (Figure 1b). Step 2: Use wrench to torque approximately 1/4 turn, creating a simultaneous fit (Figure 2). Step 3: Use .001” shim stock to check the simultaneous fit at the intersection of the tip and the shank. The shim should not be able to enter the intersection (Figure 3a). If it does, tighten further with the wrench until there is no gap (Figure 3b). Note: Pre-set torque wrenches (series DT-. . .) can be purchased. Figure 1a. Finger tight Figure 1b. .010” gap Figure 2. 1/4 turn Rigdi,FlexibleM odularysStem HighestHelxiAvailbale Figure 3a. Shim should NOT enter intersection Figure 3b. Proper fit Series DT-. . . Optional Torque Wrench 4 462