Общий каталог Ingersoll 2011 - страница 1364

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

GENERAL TECHNICAL INFORMATION FACE MACHINING TOOL SELECTION Follow these three recommendations to select the correct cutting tool: Major Diameter Depth of Cut Minor Diameter Choose the widest possible insert and Choose the shortest tool blade overhang, Choose the tool range with the largest tool, according to the cutting width according to the maximum depth required. diameter depending on the initial and geometry to be machined. grooving diameter required in the application. TOOL ADJUSTMENT Prior to machining, check and adjust the following tool positions 0.0006 Check the cutting edge height at Check parallelism of cutting edge and the centerline, machine in light turning machined surface. Correct position can down to center, and check for burr. guarantee good surface quality when face turning in both directions. 1366