Общий каталог Ingersoll 2011 - страница 1356

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

GENERAL TECHNICAL INFORMATION TURNING AND GROOVING MULTIFUNCTION OPERATIONS 0.004” Not recommended The tools are multifunctional tools able to operate in a sequence of grooving and turning modes. Moving from turning to grooving requires consideration of the basic principle to eliminate the possibility of insert breakage. In this situation one must release the side deflection necessary in turning but not recommended in grooving. MACHINING A RADIUS OR CHAMFER The machining of a corner with a radius or a chamfer larger than the radius of the insert always requires the combination of movement in two directions. Problems, such as insert breakage, result when this combined operation is used while the insert is plunged into the workpiece with material on all sides. Insert breakage is caused by forces acting simultaneously in two different directions F1 and F2 as shown. Not recommended Recommended procedure to optimize machining and eliminate insert breakage Prior move Actual move 1 2 3 4 1358