Общий каталог Ingersoll 2011 - страница 1351

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

GENERAL TECHNICAL INFORMATION ■ Recommended Cutting Conditions • Recommendations given are normal machining conditions. If excessive wear occurs, select an insert in a harder grade. If chipping or breakage occurs, select an insert in a tougher grade. • The high end of the cutting speed recommendations given are for insert widths of .118 inch and over at low-to-medium feeds. For smaller insert widths or machining at high feeds, choose a lower cutting speed. • Optimal grade selection depends also on workpiece material, diameter and rigidity of the system. ■ Recommended Cutting Conditions • T-Clamp Ultra Plus Grade Grade Grade Materials HardnessBrinell HB TT8020 TT7220 TT9030TougherHarder Cutting Speed (sfm) 0.2%C 150 360-560 Carbon Steel 0.45%C 190 330-490 .83%C 250 280-460 200 280-460 200-250 320-460 Alloy Steel 275-325 200-360 325-375 165-330 375-425 130-200 150 260-430 Cast Steel,Carbon Alloy 150-200 230-390 250-300 200-330 175-225 330-490 Martensitic 275-325 230-380 Stainless Steel 375-425 200-330 Austenitic 135-175 200-430 1353